Home > Building A Chicken Coop Video > Homemade Chicken Ark

Homemade Chicken Ark

Homemade chicken coop for our small Florida yard. Describes features, materials.

  1. rwu19290
    September 30th, 2008 at 21:02 | #1

    nice!

  2. dazco2020
    October 5th, 2008 at 04:38 | #2

    great job how are the chickens?

  3. k8923
    October 5th, 2008 at 07:51 | #3

    Chickens are doing well, and 2 months old! We’ve got 5 in the ark, but 2 are banties. The only change I’ve made to the design is to add rain flaps on the sides, since we get some powerful rain here in florida. It’s also heavier than I expected…it definitely takes 2 of us to carry it to a new location.

  4. brokenmoon65
    November 1st, 2008 at 20:51 | #4

    How do you get the blue print on this chicken coop?Great coop!

  5. Josiah531
    December 8th, 2008 at 15:25 | #5

    You might could change out the lower solid doors with door frames with chicken wire. This would cut several pounds off I would imagine. This is one of the better chicken ark/tractors that I have seen. 5 stars for the effort. Good job.

  6. carringtonblush
    April 13th, 2009 at 00:36 | #6

    Yes, Great Work!! This is one of the first designs I’ve seen that gives the chickens night-time security. Just one question – the top section looks to have no ventilation when closed-up for the night… do the chickens seem to be OK in there even on hot summer nights?

  7. k8923
    April 13th, 2009 at 02:53 | #7

    There is airflow in the peak of each triangle on the ends. I left open the top 4″, then put a smaller piece on the outside edges of the roof. This allows air to flow under it, along the roof line, and out the other end. I figured that would allow the heated air to leave without allowing in wind or rain which chickens hate. Another option would be to raise the metal roof an inch or two above the rafters and have it extend out over the wooden sides, screening the opening. Ave noc temp is 76.

  8. carringtonblush
    April 14th, 2009 at 01:02 | #8

    Thanks for your reply. This is a really well thought out design! Are copies of your plans available, or do you know of any similar plans I could get hold of? In any case, thanks very much for posting the video.

  9. k8923
    April 14th, 2009 at 05:17 | #9

    No plans that I’m aware of. You can get a pretty good idea of the construction by looking at the video. It is mainly 2×2′s creating the A frame, and cedar lap siding. The floor rests on 2×2 cross beams, with the sliding section cut so it can be slid out for access to the stairs.

  10. breebw
    April 17th, 2009 at 01:06 | #10

    inbuilt hose connector! Nice work.

  11. Sabei0990
    April 23rd, 2009 at 19:45 | #11

    Is that enough space for the chickens to live there entire life, comfortably? I wanna raise 3-4 chickens but I go to school and no one else can help all the time. Please help.

  12. k8923
    May 13th, 2009 at 07:54 | #12

    You could raise 3-4 bantams in there. I ended up adding a “playpen” onto this which was 4×5 and about 4′ tall, simply constructed out of 1×2′s and chicken wire. That way they could go out when it was nice and scratch around, but still get under when it rained, and go upstairs to bed at night. We had 3 full size chickens in this set up and they seemed very content.

  13. tfgarrity1956
    May 27th, 2009 at 15:00 | #13

    Such a nice tractor. I’ve watched your video many times as a guide to building mine. Thanks,

  14. teenmod12
    June 30th, 2009 at 23:03 | #14

    i am just about done finishing my chicken tractor. its 6 feet long, 4 feet wide, and 4 1/2 feet tall. i wanted to make it so i can move it around, but i also wanted to make it out of all recycled materials (2 by 4s and ply wood). i just tared the roof today and tomorrow im putting on cedar shingles. the bloody thing weighs well over 200lb

  15. k8923
    July 1st, 2009 at 07:57 | #15

    That’s not a tractor, that’s a mansion! You’re going to have to put a serious set of wheels under one end. You might look into the wheels on the Boughton 902. The axel is on a hinge so you can lift up one end and flip the wheels under then push or pull from the other end. Good luck.

  16. SuperChipboy
    July 16th, 2009 at 10:44 | #16

    very good design ,please can you give me the height width and depth so i can make my own.

  17. k8923
    July 16th, 2009 at 13:36 | #17

    Sold this a couple of months ago, so had to go back to my pictures to figure this out. I’m thinking the base is 3′ wide x 5′ long. The sides are about 4′, so the height ends up around 44″. The nesting area is about 18″ high, the ground area about 26″. Good luck.

  18. greenecorevolution
    October 16th, 2009 at 22:28 | #18

    nice video, thanks for sharing . heres a 3D plan view of our latest mobile chicken coop as close to free range as you can get,,, see our channel for plans,,,,many thanks

  19. KayakFisher01
    March 29th, 2010 at 14:09 | #19

    Google “city chicken website” or try backyardchickens(dot)com
    Also look at “Chicken Ark – ThePoultryPeople” here on youtube for more ideas.

  20. KayakFisher01
    March 29th, 2010 at 14:11 | #20

    Google “city chicken website” or try backyardchickens website
    Also look at “Chicken Ark – ThePoultryPeople” here on youtube for more ideas.

  21. Snowiethebunny
    May 21st, 2010 at 04:21 | #21

    1.copy and paste
    2.send this to 2 other videos.
    3.hold your breath for 10 seconds
    4.press refresh twice
    3.LOOK AT YOUR HANDS

  22. SuperSallyjean
    June 25th, 2010 at 15:17 | #22

    If you live in the area of Portland, OR or Seattle WA, why not just order one from us?
    at: the chicken tractor company dot com We deliver! Check us out! We are all about green living and love to promote it by having the tractors available for those who do not have the time to build them.

  1. No trackbacks yet.

CommentLuv Enabled